Cowl Cover Installation

Installation Instructions
Please follow the installation instructions provided with your purchase for optimum results.

Caution: Prior to starting the install, wash and dry vehicle, then allow surface temperature to warm to 70 degrees. This 70 degree surface temperature is neccessary for the proper adhesion of the tape. Cold surface temperatures can result in the part becoming loose and falling off vehicle.

RAB Products Cowl Covers

Step 1 – Center part over the cowl end. This part covers the entire area so just align all edges a closely as possible for best looking fit.

Step 2 – Peel the tape liner back about 1″ from each segment of tape. It’s advisable to peel the liner from all ends so if one piece is torn, you’ll have the other end to use. Fold the 1″ piece of liner so the end is angled outward from the edge.

Step 3 – Clean the the area where the part will be mounted with the enclosed alcohol wipe. Align the part with the surface edges and press the exposed tape corners to the cowl surface.

Step 4 – Gently hold the part in place and pull the tape liner lead outward slowly to expose the complete tape surface to the cowl. Follow this procedure for all taped edges.

Step 5 – After all tape liner has been removed carefully apply a rubbing pressure to the flange surface, to ensure complete contact with all taped surfaces to the cowl panel.

Tape will achieve best bond over a 24 hour period and should be left untouched during this time. Do not wash vehicle or allow any water to come into contact with the installation area.